■支持可烧录的IC达20357种 V2.21a(2005/12/21) ■超快的烧录速度,烧写16Mbit闪存,少于18秒
■具有自动 EPROM / FLASH 厂商及编号搜寻功能 ■支持48PIN万用驱动，兼容性强
■特有的序列号烧录功能, 可自我编辑序列号烧录文件或设置自动序列号累加烧录
■支持超低电压烧写闪存,最低可达到1.8V ■自动侦测IC插反，位置插错，提供IC自动烧录功能
■通过USBV2.0 与 PC 讯,通过网络免费更新软件 ■适用于WINDOWS 2000XP/2003/XP64操作系统
概要
ELNEC基于Windows 95/98/ME/NT/2000/XP界面的新的兼容USB的通用烧录器首要成员,能很好地满足发展的社会对于快速和可靠性通用编程器的要求.
提供非常有竞争力的价格,为可靠烧写外加卓越的硬件设计,在这方面是性价比最好的烧写器.
由于高速FPGA硬件驱动和烧写器内部时序程序运行,有着非常快的烧写速度.从这点上说至少比同类竞争品要快,对于许多芯片的烧写速度,也要比同类竞争品要快.因此,在烧录座上当要生产时,只要等待操作,而不像其它的完整操作方式.
PRO-48通过USB(2.0/1.1)口就能连接IBM 486以上的PC、手提式的、个人桌面电脑。
硬件
FPGA基于48个强有力的TTL pin驱动,为每一个测试座上的pin脚提供High/Low/Pull up/Pulldown/read功能.先进的驱动技术结合高速高质线路的可靠性能.最低支持电压低至1.8v,因此您可以用它烧录当前世界上所有流行的低压器件.
烧录器提供插入测试和接触测试在进行烧录之前,并可以防止因放置不当接触不好造成的芯片损坏.这些性能通过过流保护和流量检查因误操作阻止芯片损坏.
内嵌的保护电路能消除烧写器的损坏或因环境或误操作损坏烧写器.PRO-48烧写器的所有输入,包括ZIF测试座,连接到PC机的先进的驱动技术提供高速高质的可靠性能.最低支持电压低至1.8v,因此您可以用它烧录当前世界上所有流行的低压器件.
烧录器提供接触测试在进行烧录之前,并可以防止因放置不当造成的芯片损坏.这些通过过流保护和流量检测阻止因误操作损坏芯片.
内嵌的保护电路能消除烧写器的损害或者因环境或误操作的烧录器的损害.PRO-48烧录器的所有输入,包括ZIF测试座、连接PC的、供电 ,都被保护,防止ECD上升到15KV.PRO-48烧录器执行边沿级别的电压烧录校验,这样能明显 的提供烧录领域,保持长数据.
各种各样的适配器支持各种IC封装,例如:PLCC, SOIC,PSOP,SSOP, SSOP, TSOPTSSLP,TQFP,QFN(MLF)SDIP,BGA等.
软体
这款烧录器容易使用并进行控制,具备下拉菜单,快捷键和在线帮助.选择器件可以通过选择分类,制造厂商,型号,序列号等多种方法进行.
相关的标准烧录操作命令(read, blank check, program, verify, erase),还有一些测试功能(插入测试,流量检测),也包括一些额外的功能如(autoincrement,product 模式-在插入芯片以后立刻开始烧).
支持所有已知的数据格式,当导入文件时能自动识别并转换合适的文件格式.
自动递增烧录功能可以在每一颗IC中分配不同的序列号,也可以简单的递增序列号,也可以选择从用户自己的文件读取序列号烧录器软体提供详尽的IC讯息包括画的各种有用的封装,芯片标签的说明(前缀和后缀的意思).
VME文件通过VME Player说明.VME文件是一个关于SVF文件压缩的二进制变异,包含高层IEEE 1149.1总线实施.通过各自烧写器的厂商提供的设计软件产生VME文件.芯片在ZIF座(IEEE1149.1接口)烧录.
一个强有力的多烧写程序能实现在同一台PC(通过USB口)上连接多个PRO-48烧写器,支持许多芯片,正如单一PRO-48烧录器所支持的,同时也不会明显的降低烧录速度.众所周知,协作 的多烧录-每一烧录器能独立工作,每一烧录器也能烧录不同的芯片.
CARE FOR THE CUSTOMERS
It is important to remember, that a support of most of the new devices requires only a software update , because the PRO-48 is truly a universal programmer. With our prompt service you can have new device added to the list of supported devices within hours! See AlgOR (Algorithm On Request) service for details.
Free software updates are available by download from our WEB site.
Keep-Current and AlgOR services, our next step towards customer satisfaction.
Keep-Current service means, that ELNEC ships the latest version of programmer software and updated user documentation (Keep-Current package) to customer . The Keep-Current service is your hassle-free guarantee that you achieving the highest quality programming on ELNEC programmers, at minimal cost.
AlgOR (Algorithm On Request) service gives the user a tool to influence amount and types of programmed devices as needed.
Advanced design of the PRO-48 programmer, including protective circuits, original brand components, and careful manufacturing and burning allows us to provide a three-year warranty on parts and labor for the programmer (limited 25 000-cycle warranty on ZIF sockets).
SpecificationHARDWAREBase unit, DACs
USB 2.0 port
FPGA based IEEE 1284 slave printer port, up to 1MB/s transfer rate
on-board intelligence: powerful microprocessor and FPGA based state machine
three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
VCCP range 0..8V/1A
VPP1, VPP2 range 0..26V/1A
autocalibration
selftest capability
protection against surge and ESD on power supply input, parallel port connection
ZIF socket, pindriver
48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 48-pin
pindrivers: 48 universal
VCCP/VPP1/VPP2 can be connected to each pin
perfect ground for each pin
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
analog pindriver output level selectable from 1.8 V up to 26V
current limitation, overcurrent shutdown, power failure shutdown
ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
continuity test: each pin is tested before every programming operation
DEVICE SUPPORTProgrammer, in ZIF socket
EPROM: NMOS/CMOS, 2708*, 27xxx and 27Cxxx series, with 8/16 bit data width, full support for LV series
EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series, with 8/16 bit data width
Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx, 29Wxxx, 49Fxxx series, from 256Kbit to 32Mbit, with 8/16 bit data width, full support for LV series
Serial E(E)PROM: 24Cxxx, 24Fxxx, 25Cxxx, 45Dxxx, 59Cxxx, 25Fxxx, 25Pxxx, 85xxx, 93Cxxx, NVM3060, MDAxxx series, full support for LV series
Configuration (EE)PROM: XCFxxx, XC17xxxx, XC18Vxxx, EPCxxx, AT17xxx, 37LVxx
1-Wire E(E)PROM: DS1xxx, DS2xxx
PROM: AMD, Harris, National, Philips/Signetics, Tesla, TI
NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD U63x series
PLD: Altera: MAX 3000A, MAX 7000A, MAX 7000B, MAX 7000S, MAX7000AE
other PLD: SPLD/CPLD series: AMI, Atmel, AMD-Vantis, Gould, Cypress, ICT, Lattice, NS, Philips, STM, VLSI, TI
Microcontrollers 48 series: 87x41, 87x42, 87x48, 87x49, 87x50 series
Microcontrollers 51 series: 87xx, 87Cxxx, 87LVxx, 89Cxxx, 89Sxxx, 89LVxxx, all manufacturers, Philips LPC series
Microcontrollers Intel 196 series: 87C196 KB/KC/KD/KT/KR/...
Microcontrollers Atmel AVR: AT90Sxxxx, ATtiny, ATmega series
Microcontrollers Cypress: CY8Cxxxxx
Microcontrollers ELAN: EM78Pxxx
Microcontrollers Microchip PICmicro: PIC10xxx, PIC12xxx, PIC16xxx, PIC17Cxxx, PIC18xxx, dsPIC series
Microcontrollers Motorola: 68HC05, 68HC08, 68HC11 series
Microcontrollers National: COP8xxx series
Microcontrollers NEC: uPD78Pxxx series
Microcontrollers Scenix (Ubicom): SXxxx series
Microcontrollers SGS-Thomson: ST6xx, ST7xx, ST10xx series
Microcontrollers TI: MSP430 and MSC121x series
Microcontrollers ZILOG: Z86/Z89xxx and Z8xxx series
Microcontrollers other: EM Microelectronic, Fujitsu, Goal Semiconductor, Hitachi, Holtek, Princeton, Macronix, Winbond, Infineon(Siemens), NEC, Samsung, Toshiba, ...
PIC18xxx, dsPIC series
Microcontrollers Motorola/Freescale: HC08 GT, LJ, QY, QT series
Microcontrollers Philips: LPC series
Microcontrollers TI: MSP430
Various PLD (also by JAM player/JTAG support):
Altera: MAX 3000A, MAX 7000A, MAX 7000B, MAX 7000S, MAX 9000, MAX II
Xilinx: XC9500, XC9500XL, XC9500XV, CoolRunner XPLA3, CoolRunner-II
Notes:
devices marked * are obsolete, programming with additional module
for all supported devices see actual DEVICE LIST
I.C. Tester
TTL type: 54,74 S/LS/ALS/H/HC/HCT series
CMOS type: 4000, 4500 series
Static RAM: 6116 .. 624000
User definable test pattern generation
Package support
package support includes DIP, PLCC, SOIC, PSOP, SSOP, TSOP, TSSOP, TQFP, QFN (MLF), SDIP, BGA and other
support all devices in DIP with default socket
support devices in non-DIP packages up to 48 pins with universal adapters
programmer is compatible with third-party adapters for non-DIP support
Programming speedNotes:
It is important to know, we always use random numbers pattern for programming speed testing. Some our competitors use "sparse" pattern, where only few non-Blak data are programmed or are there are used data with only few 0 bits (FE, EF, etc.). This cheating approach can "decrease" programming time considerable. If you plan to compare, ask always which pattern they use.
The programming speed depends on PC speed only slightly. |
